2008 Jeep Compass Owner Manual - Page 139

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 139 Using HomeLinkா To operate, simply press and release the programmed HomeLink௡ button. Activation will now occur for the trained device (i.e. garage door opener, gate operator, security system, entry door lock, home/office lighting, etc. The hand-held transmitter of the device may also be used at any time. Reprogramming a Single HomeLinkா Button To re-program a channel that has been previously trained, follow these steps: 1. Turn the ignition switch to the ON/RUN position. 2. Press and hold the desired HomeLink௡ button until the indicator light begins to flash after 20 seconds. Do not release the button. 3. Without releasing the button, proceed with PROGRAMMING HOMELINK Step #2 and follow all remaining steps. Security It is advised to erase all channels before you sell or turn in your vehicle. To do this, press and hold the two outside buttons for 20 seconds until the red indicator flashes. Note that all channels will be erased. Individual channels cannot be erased. The HomeLink௡ Universal Transceiver is disabled when the Vehicle Theft Alarm is active. 3