2008 Jeep Wrangler Owner's Manual - Page 208

UNDERSTANDING YOUR INSTRUMENT PANEL 207 7. Seat Belt Indicator Light A warning chime and an indicator light will alert you to buckle the seat belts. When the belt is buckled, the chime will stop, but the light will stay on until it times out (about six seconds). 8. Turn Signal Indicator Lights The arrows will flash with the exterior turn signals when the turn signal lever is operated. A tone will chime if the turn signals are left on for more than 1 mi (2 km). 9. Oil Pressure Warning Light Shows low engine oil pressure. The light will come on and remain on when the ignition switch is turned from the OFF to the ON position, and the light will turn off after the engine is started. If the bulb does not come on, have the system checked by your authorized dealer. If the warning light comes on and remains on while driving, stop the vehicle and shut off the engine. DO NOT OPERATE THE VEHICLE UNTIL THE CAUSE IS CORRECTED. Also, a single chime will sound. 10. High Beam Indicator Light This light shows that the headlights are on high beam. Push the multifunction control lever away from you to switch the headlights to high beam. Pull the lever towards you to switch the headlights back to low beam. If the driver's door is open, and the headlights or park lights are left on, the High Beam Indicator Light will remain illuminated and a chime will sound. 11. Brake Warning Light After the ignition is turned on, this light illuminates to indicate function check at vehicle startup. It also indicates if the parking brake is applied. If the light stays on when the parking brake is 4