2013 Jeep Wrangler Owner's Manual - Page 20

18 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 4. Insert a blank Sentry Key௡ into the ignition switch. Turn the ignition switch to the ON/RUN position If you have two valid Sentry Keys௡, you can program within 60 seconds. After 10 seconds, a single chime new Sentry Keys௡ to the system by performing the will sound. In addition, the Vehicle Security Light will following procedure: stop flashing. To indicate that programming is com1. Cut the additional Sentry Key௡ Transponder blank(s) plete, the Vehicle Security Light will turn on again for to match the ignition switch lock cylinder key code. three seconds and then turn off. Customer Key Programming 2. Insert the first valid key into the ignition switch. Turn the ignition switch to the ON/RUN position for at least three seconds, but no longer than 15 seconds. Then, turn the ignition switch to the LOCK position and remove the first key. The new Sentry Key௡ is programmed. The Remote Keyless Entry (RKE) transmitter will also be programmed during this procedure. Repeat this procedure to program up to eight keys. If you do not have a programmed Sentry Key௡, contact your 3. Insert the second valid key into the ignition switch. authorized dealer for details. Turn the ignition switch to the ON/RUN position within 15 seconds. After 10 seconds, a chime will sound. In addition, the Vehicle Security Light will begin to flash. Turn the ignition switch to the LOCK position and remove the second key.