2013 Jeep Wrangler User Guide - Page 78

ELECTRONICS Mute (Or Unmute) Microphone During Call • During a call, press the "Voice Command" button • After the BEEP, say "mute" (or "mute off"). . Transfer Ongoing Call Between Handset And Vehicle • During a call, press the "Voice Command" button • After the BEEP, say "transfer call". . Changing The Volume • Start a dialogue by pressing the "Phone" button a normal call. , then adjust the volume during • Use the radio ON/OFF VOLUME rotary knob to adjust the volume to a comfortable level while the Uconnect® system is speaking. Please note the volume setting for Uconnect® is different than the audio system. WARNING! • Any voice commanded system should be used only in safe driving conditions following applicable laws regarding phone use. Your attention should be focused on safely operating the vehicle. Failure to do so may result in a collision causing you and others to be severely injured or killed. • In an emergency, to use Uconnect® Phone, your mobile phone must be: • turned on, • paired to Uconnect® Phone, • and have network coverage. Uconnect® VOICE COMMAND Voice Command Operation • The Uconnect® Voice Command system allows you to control your AM, FM radio, satellite radio, disc player, HDD, Uconnect® Phone, a memo recorder, and supported portable media devices. • When you press the "Voice Command" button located on the radio faceplate or steering wheel, you will hear a beep. The beep is your signal to give a command. If you do not say a command within a few seconds, the system will present you with a list of options. If you ever wish to interrupt the system while it lists options, press , listen for the BEEP, and say your command. the "Voice Command" button 76