2013 Jeep Wrangler User Guide - Page 80
2013 Jeep Wrangler Manual
Page 80 highlights
ELECTRONICS While In: Voice Command Example: To switch to the voice recorder mode, say "Memo". The following are common voice commands for this mode: "New Memo" (to record a new memo) - During the recording, you to stop recording. may press the Voice Command button You proceed by saying one of the following commands: - "Save" (to save the memo) - "Continue" (to continue recording) - "Delete" (to delete the recording) - "Play Memos" (to play previously recorded memos) - During the playback you may press the Voice Command button to stop playing memos. You proceed by saying one of the following commands: - "Repeat" (to repeat a memo) - "Next" (to play the next memo) - "Previous" (to play the previous memo) - "Delete" (to delete a memo) - "Delete All" (to delete all memos) Memo Mode Voice Text Reply • If equipped with Uconnect® Voice Command, your Uconnect® 430N, 730N & 731N radios may be able to play incoming Short Message Service (SMS) messages (text messages) through the vehicle's sound system. • It also allows you to respond by selecting from various pre - defined phrases. • Not all phones are compatible with this feature. Refer to the phone compatibility list at www.UconnectPhone.com. Connected mobile phones must be bluetoothcompatible and paired with your radio. • Press the "Voice Command" button started. and after the BEEP, say "SMS" to get NOTE: To access the tutorial, press the "Voice Command" button . After the BEEP, say "tutorial". Press any hard-key/button or touch the display (Touch-Screen radio) to cancel the tutorial. WARNING! Any voice commanded system should be used only in safe driving conditions following applicable laws regarding phone use. Your attention should be focused on safely operating the vehicle. Failure to do so may result in a collision causing you and others to be severely injured or killed. 78