2014 Jeep Cherokee Owner Manual - Page 234

232 UNDERSTANDING THE FEATURES OF YOUR VEHICLE ParkSense® will retain the last system state (enabled or (200 cm) from the rear fascia/bumper in the horizontal disabled) from the last ignition cycle when the ignition is direction, depending on the location, type and orientation of the obstacle. changed to the ON/RUN position. ParkSense® can be active only when the shift lever is in REVERSE. If ParkSense® is enabled at this shift lever position, the system will remain active until the vehicle speed is increased to approximately 7 mph (11 km/h) or above. When in REVERSE and above the system's operating speed, a warning will appear in the EVIC indicating the vehicle speed is too fast. The system will become active again if the vehicle speed is decreased to speeds less than approximately 6 mph (9 km/h). ParkSense® Warning Display The ParkSense® Warning screen will only be displayed if Sound and Display is selected from the Customer Programmable Features section of the Uconnect® System. Refer to ЉUconnect® Settings" in "Understanding Your Instrument Panel" for further information. The ParkSense® Warning screen is located within the Electronic Vehicle Information Center (EVIC). It provides visual warnings to indicate the distance between the rear ParkSense® Sensors fascia/bumper and the detected obstacle. Refer to "ElecThe four ParkSense® sensors, located in the rear fascia/ tronic Vehicle Information Center (EVIC)/Settings" in bumper, monitor the area behind the vehicle that is "Understanding Your Instrument Panel" for further inwithin the sensors' field of view. The sensors can detect formation. obstacles from approximately 12 in (30 cm) up to 79 in