2015 Kawasaki Mule 610 4x4 XC SE Owners Manual - Page 121
2015 Kawasaki Mule 610 4x4 XC SE Manual
Page 121 highlights
120 MAINTENANCE AND ADJUSTMENT Battery Installation that the rubber dampers on the battery • Check holder and the battery case are properly in place. the battery in place, and route the battery vent • Put hose through the hole in the floor board. the capped lead to the (+) terminal, and • Connect then connect the black lead to the (-) terminal. a light coat of grease on the terminals to pre• Put vent corrosion. the (+) terminal with its protective cap. • Cover • Reinstall the battery holder and rubber mud cover. j DANGER A. B. C. D. Bolt Holder (-) Terminal (+) Terminal the leads from the battery, first from • Disconnect the (-) terminal and then the (+) terminal. the battery out of the case. • Lift the battery using a solution of baking soda • Clean and water. Be sure that the lead connections are Batteries contain sulfuric acid that can cause burns and produce hydrogen gas which is highly explosive. Use caution when handling batteries and do not expose them to spark or flame. Read and understand the battery safety label. NOTICE Do not reverse the battery connections, or damage to the regulator/rectifier unit will result. Battery Characteristics The battery installed in this Mule is a conventional type and requires regular inspection to maintain the proper electrolyte level and a full charge. • clean. Perform a visual inspection. Inspect for defective or cracked case and cover, and loose or damaged terminal posts or cables. Replace battery and/or cables immediately if any damage is found. Yuasa Battery YB14A-A2 Make Type