1999 Lexus RX 300 Owners Manual - Page 104
1999 Lexus RX 300 Manual
Page 104 highlights
INTERIOR EQUIPMENT 2. Bring the hand held garage door opener within about 25 mm (1 in.) of the button being programmed and push the button on the hand held garage door opener. The signal from the hand held garage door opener is sent to the vehicle's opener. 3. When the frequency and code is registered, the indicator light flashes rapidly. At this point, you can release both buttons. 4. To program the remaining buttons, repeat steps "1" through "3". If you want to replace an existing program with a new program, select the button you want to program. Follow the procedure from step 1. If the transmitter has a "rolling code feature", it is necessary to program the in-garage receiver after programming HomeLinkR. 1. Locate the "training" or "learning" button on the in-garage receiver and push and release this button. Location of the button may vary by the garage door opener manufacturer. 2. Firmly push and release the trained HomeLinkR button 2 times (some garage door manufacturer may require you to push the HomeLinkR button up to 3 times) to complete the process. The garage door should now operate when the HomeLinkR button is pushed. 87 Do not use the HomeLinkR universal transmitter with any garage door opener that lacks the safety stop and reverse feature as required by Federal Safety Standards. This includes any garage door opener model manufactured before April 1, 1982.