2001 Lexus GS 300 User Guide 1 - Page 76
2001 Lexus GS 300 Manual
Page 76 highlights
INTERIOR EQUIPMENT GARAGE DOOR OPENER The garage door opener is manufactured under license from HomeLinkR and can be programmed to operate garage doors, estate gates, security lighting, etc. 2. Bring the hand held garage door opener within about 25 mm (1 in.) of the button being programmed and push the button on the hand held garage door opener. The signal from the hand held garage door opener is sent to the vehicle's opener. 3. When the frequency and code is registered, the indicator light flashes rapidly. At this point, you can release both buttons. 4. To program the remaining buttons, repeat steps "1" through "3". If you want to replace an existing program with a new program, select the button you want to program. Follow the procedure from step 1. (a) Programming HomeLinkR 14G015-1 If the transmitter has a "rolling code feature", it is necessary to program the in-garage receiver after programming HomeLinkR. 1. Locate the "training" or "learning" button on the in-garage receiver and push and release this button. Location of the button may vary by the garage door opener manufacturer. 2. Firmly push and release the trained HomeLink R button 2 times (some garage door manufacturer may require you to push the HomeLinkR button up to 3 times) to complete the process. The garage door should now operate when the HomeLinkR button is pushed. " 1 Buttons 2 Indicator light The has 3 buttons and can be programmed to operate 3 separate devices. Prepare the HomeLinkR for programming by erasing all codes or the memorized data programmed by the former owner. Follow the procedure in "(c) Erasing the garage door opener memory". 1. Decide which one of the 3 buttons you want to program. Push and hold down the button for about 20 seconds until the indicator light begins to flash. While holding this button, follow steps "2" and "3". 58 HomeLinkR