2012 Lexus HS 250h Owners Manual - Page 399

400

3-7. Other interior features

■

Programming a rolling code system (for U.S. owners)

If your device is rolling code equipped, follow the steps under the

heading “Programming HomeLink

®

” before proceeding with the

steps listed below.

Locate the training button on the ceiling mounted garage door

opener motor. The exact location and color of the button may

vary by brand of garage door opener motor.

Refer to the operation manual supplied with the garage door opener

for the location of the training button.

Press the training button.

Following this step, you have 30 seconds in which to initiate step 3

below.

Press and hold the vehicle’s programmed HomeLink

®

button for

2 seconds and release it. Repeat this step once again. The garage

door may open.

If the garage door opens, the programming process is complete. If the

door does not open, press and release the button a third time. This third

press and release will complete the programming process by opening

the garage door.

The ceiling mounted garage door opener motor should now recognize

the HomeLink

®

signal and operate the garage door.

Repeat the steps above to program another rolling code system

for any of the remaining HomeLink

®

buttons.

■

Programming an entry gate (for U.S. owners)/Programming a

devices in the Canadian market

Place the remote control transmitter 1 to 3 in. (25 to 75 mm)

away from the HomeLink

®

buttons.

Keep the HomeLink

®

indicator light in view while programming.

Press and hold the selected HomeLink

®

button.

Repeatedly press and release (cycle) the remote control trans-

mitter for 2 seconds each until step 4 is completed.

When the HomeLink

®

indicator light starts to flash rapidly,

release the buttons.