2005 Lincoln Aviator Owner Guide 3rd Printing - Page 105

Lights Autolamp exit time delay, manual sequence This option allows you to change the length of the autolamp exit delay. To program the auto lamp exit time delay: 1. Start with the ignition in the OFF/LOCK position and the autolamps selected. 2. Deselect the auto lamps. 3. Turn the ignition to the ON position. 4. Turn the ignition to the OFF/LOCK position. 5. Select the autolamps. • Note: Steps 2 through 5 must be performed within a 10 second period. • At this point, the headlamps and park lamps will turn on. 6. Deselect the auto lamps after the desired auto lamp delay time (maximum of 3 minutes). • At this point, the headlamps and park lamps will turn off. The default for autolamp exit delay time is 20 seconds. Following a vehicle battery disconnect/reconnect auto lamp delay exit time will be retained. Autolamp exit time delay, message center sequence This option allows you to change the length of time of the autolamp exit delay using the message center. You will have the ability to change the autolamp exit delay time of the autolamp ON time when the instrument cluster message center is enabled (ignition in ON or accessory position). There are 8 distinct and separate set points or values for auto lamp delay exit time in seconds. The following are predefined set points or auto lamp exit delay time values: 0, 10, 20, 30, 60, 90, 120, 180, seconds (i.e. 0 to 3 minutes). The following steps are used to program the autolamp exit time delay using the message center: 1. The message center will display the last autolamp exit delay time in seconds. 2. You can respond to this message by 1 of 4 methods: • No Response - The message center then times out after 4 seconds and displays it's normal text information. • Press the info button - The message center then displays its normal text information. 105 2005 Aviator (231) Owners Guide (post-2002-fmt) USA (fus)