2008 Lincoln MKZ Owner Guide 2nd Printing - Page 48

Lights 3. Disengage top of flexible washer bottle filler neck from snap strap attachment and position it to gain access to the high beam bulb (passenger side only). 4. Remove the bulb socket by rotating it counterclockwise, then pulling it straight out of the lamp assembly. 5. Discard the old bulb and install the new bulb into bulb socket. 6. Install the new bulb socket into the lamp assembly by aligning the indexing fingers, then rotate clockwise to locked position. 7. If required, position the flexible washer bottle filler neck back to its original position and connect the snap strap (passenger side only). 8. If required, reinstall the air tube to the air filter assembly (driver side only). Replacing stop/tail/turn and side marker bulbs Your vehicle is equipped with a rear lamp that has a stop/tail/turn and side marker lamp module containing integral multiple light emitting diodes (LED). If one or more LEDs burn out, the complete lamp module has to be replaced. See your authorized dealer for the replacement LED module. Replacing rear turn signal bulbs 1. Make sure the headlamp switch is in the O (Off) position and open the trunk. 48 2008 MKZ (378) Owners Guide (post-2002-fmt) USA (fus)