2010 Lincoln MKZ Owner Guide Supplement 1st Printing - Page 7

1. Firmly press the two outer Car2U௡ system buttons for 1-2 seconds, then release. 2. Go to the garage to locate the garage door opener motor and its "learn" button. You may need a ladder to reach the unit and you may need to remove the unit's cover or light lens to locate the "learn" button. Press the "learn" button, after which you will have 10-30 seconds to return to your vehicle and complete the following steps. If you cannot locate the "learn" button, refer to the Owner's Guide of your garage door opener or call the toll-free Car2U௡ system help line at 1-866-57Car2U (1-866-572-2728). 3. Return to your vehicle. Press and hold the Car2U௡ system button you would like to use to control the garage door. You may need to hold the button from 5-20 seconds, during which time the selected button indicator light will blink slowly. Immediately (within 1 second) release the button once the garage door moves. When the button is released, the indicator light will begin to blink rapidly until programming is complete. 4. Press and release the button again. The garage door should move, confirming that programming is successful. If your garage door does not operate, repeat the previous steps in this section. After successful programming, you will be able to operate your Car2U௡ system by pressing the button you programmed to activate the opener. The indicator light above the selected button will turn on to confirm that the Car2U௡ system is responding to the button command. To program another rolling code device such as an additional garage door opener, a security device or home lighting, repeat Steps 1 through 4 substituting a different function button in Step 3 than what you used for the garage door opener. For example, you could assign the left-most button to the garage door, the center button to a security device, and the right-most button to another garage door opener. 3