2011 Lincoln MKT Owner Guide 1st Printing - Page 100

Lights Note: The programming sequence will end if either of the following occur: • The vehicle speed is not zero. • The battery voltage is out of normal range. Troubleshooting If the automatic high beam camera becomes blocked, the high beams may not come on automatically. They will only activate when they are manually turned on with the multi-function lever. Typical road dust, dirt and water spots will not affect the automatic high beam system's performance. However, in cold or inclement weather conditions, the automatic high beam system's availability may be decreased. In such conditions, the manual override may be used to turn the high beams on or off. For significant blockages (e.g. bird dropping, bug splatter, snow, or ice), the automatic high beam system uses a blocked sensor computer program. If a blockage is detected and no changes are observed, the system will go into low beam mode until the blockage is cleared. If blockages are repeatedly detected, the system will stay in low beam mode for the remainder of the ignition cycle unless the system is able to begin detecting other vehicles again. If it appears that automatic control of the high beams is not functioning properly, check the windshield in front of the camera for blockage. Flash-to-pass Pull and release to activate. 2 1 Daytime running lamps (DRL) (if equipped) Turns the front fog lamps on. To activate: • the ignition must be in the on position, • the headlamp control is in the off, autolamps or parking lamp position and 100 2011 MKT (mkt) Owners Guide, 1st Printing USA (fus)