2013 Lincoln MKS Owner Manual Printing 2 - Page 28

28 Child Safety Child seat positioning for LATCH lower anchors All the LATCH lower anchors are equally spaced, 11 in. (28 cm) apart, allowing for the following child seat positioning: • If a single child seat is installed using the LATCH lower anchors, it can be installed at any rear seating position. • If two child safety seats are installed using the LATCH lower anchors, they must be placed in the outboard seating positions only. • If three child safety seats are installed, you can install two using the LATCH lower anchors by placing them in each outboard seating position and the third in the center using the lap and shoulder belt, OR you can use the LATCH lower anchors for the center child safety seat and the lap and shoulder belts for the other two child safety seats in the outboard positions. Use the tether anchors if applicable. Combining Safety Belt and LATCH Lower Anchors for Attaching Child Safety Seats When used in combination, either the safety belt or the LATCH lower anchors may be attached first, provided a proper installation is achieved. Attach the tether strap afterward, if included with the child seat. Using Tether Straps Many forward-facing child safety seats include a tether strap which extends from the back of the child safety seat and hooks to an anchoring point called the top tether anchor. Tether straps are available as an accessory for many older safety seats. Contact the manufacturer of your child seat for information about ordering a tether strap, or to obtain a longer tether strap if the tether strap on your safety seat does not reach the appropriate top tether anchor in the vehicle. Once the child safety seat has been installed using either the safety belt, the lower anchors of the LATCH system, or both, you can attach the top tether strap. 2013 MKS (mks) Owners Guide gf, 2nd Printing USA (fus)