2014 Lincoln Navigator L Quick Reference Guide Printing 1 - Page 3

2014 Lincoln Navigator L Manual

Page 3 highlights

Instrument Panel 1 Lighting Control Turns on the headlamps. To operate your rear window wiper:   Turn the rear wiper control to 1 (slower intermittent speed), 2 (faster intermittent Turns the headlamps off. speed) or O (off). For a rear wash cycle, control to either rotate and hold the Turns on the parking lamps. the top or bottom position to activate the  Autolamps: Automatically turns the exterior rear washer. The control will return to the lamps on/off based on available daylight. 2 or 0 position when you release it.  Turns on fog lamps by pulling the control  Note: For optimal wiper performance, clean toward you. The fog lamps can be turned your blades and glass regularly. Refer to on when the ignition is on and the lighting your Owner's Manual for more information. control knob is in the parking lamps on, Cruise Control headlamps on, or autolamps positions and the high beams are not turned on. To set the speed: 2014 NAVIGATOR  To return to a previously set speed, press RESUME.  To turn off, press OFF or turn off the ignition. 5 Information Display 4 2 Parking Brake 3  Windshield Wipers and Washers 1. Press and release ON. 2. Accelerate to the desired speed. 3. Press SET+ and take your foot off the accelerator.  To set a higher or lower speed, press and hold SET+/SET- until the desired speed is reached. You can also press and release either button to change your set speed minimally (in approximately 1 mph [2 km/h] increments).  To cancel a set speed, tap the brake pedal. The set speed will not be erased. 6 Service Engine Soon Light Shows important vehicle information through a constant monitor of vehicle systems. The display will notify you of potential vehicle problems by showing system warnings followed by a long indicator tone. For more details about your information display functions, please see your Owner's Manual. Illuminates briefly when the ignition is turned on. If it remains on or is blinking after the engine is started, the On-Board Diagnostics (OBD-II) system has detected a malfunction. Drive in a moderate fashion and contact your authorized dealer as soon as possible. Rotate the end of the control stalk away from you/toward you to increase/decrease the speed of the wipers. 4  o use the washer feature, push the end T of the stalk: Quickly for a single swipe without fluid.  Hold briefly for three swipes with washer fluid. Hold for a longer wash cycle. 7 Hazard Control 5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8

1
Lighting Control
Turns on the headlamps.
Turns the headlamps off.
Turns on the parking lamps.
Autolamps: Automatically turns the exterior
lamps on/off based on available daylight.
Turns on fog lamps by pulling the control
toward you. The fog lamps can be turned
on when the ignition is on and the lighting
control knob is in the parking lamps on,
headlamps on, or autolamps positions and
the high beams are not turned on.
2
Parking Brake
3
Windshield Wipers and Washers
Rotate the end of the control stalk away
from you/toward you to increase/decrease
the speed of the wipers.
To use the washer feature, push the end
of the stalk:
Quickly for a single swipe without fluid.
Hold briefly for three swipes with
washer fluid.
Hold for a longer wash cycle.
To operate your rear window wiper:
Turn the rear wiper control to
1
(slower
intermittent speed),
2
(faster intermittent
speed) or
O
(off). For a rear wash cycle,
rotate and hold the
control to either
the top or bottom position to activate the
rear washer. The control will return to the
2
or
0
position when you release it.
Note:
For optimal wiper performance, clean
your blades and glass regularly. Refer to
your
Owner s Manual
for more information.
4
Cruise Control
To set the speed:
1. Press and release
ON.
2. Accelerate to the desired speed.
3.
Press
SET+
and take your foot
off the accelerator.
To set a higher or lower speed, press
and hold
SET+/SET
until the desired
speed is reached. You can also press
and release either button to change your
set speed minimally (in approximately
1 mph [2 km/h] increments).
To cancel a set speed, tap the brake
pedal. The set speed will not be erased.
To return to a previously set speed,
press
RESUME
.
To turn off, press
OFF
or turn off
the ignition.
5
Information Display
S
hows important vehicle information
through a constant monitor of vehicle
systems. The display will notify you of
potential vehicle problems by showing
system warnings followed by a long
indicator tone. For more details about
your information display functions,
please see your
Owner s Manual
.
6
Service Engine Soon Light
Illuminates briefly when the ignition
is turned on. If it remains on or is
blinking after the engine is started, the
On-Board Diagnostics (OBD-II) system
has detected a malfunction. Drive in
a moderate fashion and contact your
authorized dealer as soon as possible.
7
Hazard Control
4
5
Instrument Panel
201 4 NAVIGATOR