2008 Mazda MAZDA3 Owner's Manual - Page 311

Maintenance and Care Owner Maintenance Replacing a fog light bulbs í 1. Turn the screw counterclockwise and remove it and then partially peel back the mudguard. NOTE l l l To replace the bulb, contact an Authorized Mazda Dealer. If the halogen bulb is accidentally touched, it should be cleaned with rubbing alcohol before being used. Use the protective cover and carton for the replacement bulb to dispose of the old bulb promptly and out of the reach of children. Front turn signal lights/Side-marker lights Due to the complexity and difficulty of the procedure, the bulbs should be replaced by an Authorized Mazda Dealer. Side turn signal lights 2. Disconnect the electrical connector from the bulb by pressing the tab on the connector with your finger and pulling the connector downward. 3. Turn the socket and bulb assembly to remove it. Carefully remove the bulb from its socket in the reflector by gently pulling it straight back out of the socket. 1. Slide the unit as shown in the figure to remove it. 2. Detach the electrical connector from the unit by pulling it to the rear. 3. Install the new side turn signal unit in the reverse order of removal. NOTE 4. Install the new bulb in the reverse order of removal. Bulb replacement is not possible because it is built into the unit. Replace the unit. í Some models. 8-43