2005 Mercedes CLK-Class Owner's Manual - Page 168
2005 Mercedes CLK-Class Manual
Page 168 highlights
Controls in detail Automatic transmission An additional indication of the current gear selector lever position can be found on the cover of the shifting-gate. The indicators come on when you activate a switch (e.g. unlocking the vehicle or opening a door) and go out after approximately 15 minutes. Warning! 1 Current gear range/gear selector lever position 2 Current program mode The current gear range/gear selector lever position and program mode (C/S) or (M/C/S) appear in the multifunction display. ! Allow engine to warm up under low load use. Do not place full load on the engine until the operating temperature has been reached. Shift into reverse gear R or parking position P only when the vehicle is stopped. Avoid spinning of a drive wheel for an extended period when driving off on slippery road surfaces. This may cause serious damage to the drivetrain which is not covered by the Mercedes-Benz Limited Warranty. When the gear selector lever is in position D, you can influence transmission shifting by: limiting the gear range changing gears manually G It is dangerous to shift the gear selector lever out of P or N if the engine speed is higher than idle speed. If your foot is not firmly on the brake pedal, the vehicle could accelerate quickly forward or reverse. You could lose control of the vehicle and hit someone or something. Only shift into gear when the engine is idling normally and when your right foot is firmly on the brake pedal. 166