2006 Mercedes C-Class Owner's Manual - Page 276
2006 Mercedes C-Class Manual
Page 276 highlights
Controls in detail Useful features Step 3: Hold the end of the hand-held remote control 5 of the device you wish to train approximately 2 to 5 in (5 to12 cm) away from the signal transmitter button (2, 3 or 4) to be programmed, while keeping the indicator lamp 1 in view. Step 4: Using both hands, simultaneously press the hand-held remote control button 6 and the desired signal transmitter button (2, 3 or 4). Do not release the buttons until step 5 is completed. The indicator lamp 1 will flash, first slowly and then rapidly. i The indicator lamp 1 flashes immediately the first time the signal transmitter button is programmed. If this button has already been programmed, the indicator lamp will only start flashing after 20 seconds. Step 5: After the indicator lamp 1 changes from a slow to a rapidly flashing light, release the hand-held remote control button and the signal transmitter button. Step 6: Press and hold the just-trained signal transmitter button (2, 3 or 4) and observe the indicator lamp 1. If the indicator lamp 1 stays on constantly, programming is complete and your device should activate when the respective signal transmitter button (2, 3 or 4) is pressed and released. i If the indicator lamp 1 flashes rapidly for about 2 seconds and then turns to a constant light, continue with programming steps 8 through 12 as your garage door opener may be equipped with the "rolling code" feature. 275