2010 Mercedes SLK-Class Owner's Manual - Page 200

171_AKB; 3; 60, en-US d2ureepe, 2009-05-11T16:00:23+02:00 - Seite 198 Version: 2.11.8.1 198 Tires and wheels the tires have sustained damage, replace them. When replacing rims, only use genuine Mercedes-Benz wheel bolts specified for the particular rim type. Failure to do so can result in the bolts loosening and possibly an accident. Retreaded tires are not tested or recommended by Mercedes-Benz, since previous damage cannot always be recognized on retreads. The operating safety of the vehicle cannot be assured when such tires are used. inflation pressure loss and damage to the tire beads. RIf the vehicle is heavily loaded, check tire inflation pressure and correct as required. not allow your tires to wear down too far. Adhesion properties on wet roads are sharply reduced at tread depths of less than 1/8 in (3 mm). replacing individual tires, you should mount new tires on the front wheels first (on vehicles with same-sized wheels all around). RDo RWhen Operation If you feel a sudden significant vibration or ride disturbance, or you suspect that possible damage to your vehicle has occurred, you should turn on the hazard warning flashers, carefully slow down, and drive with caution to an area which is a safe distance from the road. Inspect the tires and the vehicle underbody for possible damage. If the vehicle or tires appear unsafe, have the vehicle towed to the nearest authorized Mercedes-Benz Center or tire dealer for repairs. G Warning! Recommended tire inflation pressure Follow recommended tire inflation pressures. Do not underinflate tires. Underinflated tires wear excessively and/or unevenly, adversely affect handling and fuel economy, and are more likely to fail from being overheated. Do not overinflate tires. Overinflated tires can adversely affect handling and ride comfort, wear unevenly, increase stopping distance, and result in sudden deflation (blowout) because they are more likely to become punctured or damaged by road debris, potholes etc. Do not overload the tires by exceeding the specified load limit as indicated on the Tire and Loading Information placard on the driver's door B-pillar. Overloading the tires can overheat them, possibly causing a blowout. Overloading the tires can also result in handling or steering problems, or brake failure. G Warning! Do not drive with a flat tire. A flat tire affects the ability to steer or brake the vehicle. You could lose control of the vehicle. Continued driving with a flat tire or driving at high speed with a flat tire will cause excessive heat buildup and possibly a fire. G Warning! Important guidelines ROnly use sets of tires and rims of the same type and make. in new tires for approximately 60 miles (100 km) at moderate speeds. check the tires and rims for damage. Dented or bent rims can cause tire RTires must be of the correct size for the rim. RBreak RRegularly Your vehicle is equipped with the Tire and Loading Information placard located on the driver's door B-pillar (Y page 205). The tire inflation pressure should be checked regularly. Only adjust the tire inflation pressure on cold tires. The tires can be considered cold if the vehicle has been parked for at least 3 hours or driven less than