2002 Mercury Villager Owner's Manual - Page 98

Driver Controls Operating the HomeLink Universal Transceiver To operate, simply press and release the appropriate HomeLink button. Activation will now occur for the trained product (garage door, gate operator, security system, entry door lock, or home or office lighting etc.). For convenience, the hand-held transmitter of the device may also be used at any time. In the event that there are still programming difficulties, contact Homelink at www.homelink.com.or 1-800-355-3515. Rolling code programming To train a garage door opener (or other rolling code equipped devices) with the rolling code feature, follow these instructions after completing the "Programming" in this section. (A second person may make the following training procedures quicker & easier) 1. Locate the "learn" or "smart" button on the garage door motor head unit. Exact location and color of the button may vary by product brand. If there is difficulty locating the "learn" or "smart" button refer to the device's owner manual or contact Homelink at 1-800-355-3515 or on the Internet at www.homelink.com. 2. Press and release the "learn" or "smart" button on the garage door motor head unit. Note: Following step 2, there are 30 seconds in which to initiate step 3. 3. Press and release the programmed HomeLink button. Press and release the HomeLink button a second time to complete the training process. (Some garage door openers may require this procedure to be done a third time to complete the training.) The rolling code equipped device should now recognize the Homelink signal and activate when the Homelink button is pressed. The remaining two buttons may now be programmed if this has not previously been done. Refer to the "Programming" in this section. 98