2007 Mercury Monterey Owner Guide 1st Printing - Page 105

Locks and Security • Press 1 • 2 to recall the Driver 1 position. • Press 3 • 4 to recall the Driver 2 position. 5. After five seconds of keypad inactivity, programming mode is exited. All of the vehicle doors will lock and unlock to confirm the code has been stored. Each memory feature driver position (Driver 1 or Driver 2) can be associated with only one personal code. The factory-set code cannot be associated with a memory recall position. You can program up to three personal codes; these codes do not replace the factory-set code. Tips for setting codes: • The factory set code cannot be erased or changed. • The factory code will work even after you have set your own personal codes. • Do not set a code that uses five of the same number. • Do not use five numbers in sequential order. Erasing personal code 1. Enter the factory set 5-digit code. 2. Within five seconds of entering the factory code, press and release the 1 • 2 control. The door locks will lock and quickly unlock to confirm entry into the programming mode. 3. Within five seconds of Step 2, press and hold the 1 • 2 for two seconds to erase the customer programmed code. The programming mode is exited after five seconds of keypad inactivity. The door locks will lock and quickly unlock to confirm programming mode has been exited. The personal code is now erased and only the factory set 5-digit code will work. Unlocking and locking the doors using keyless entry To unlock the driver's door, enter the factory set 5-digit code or your personal code. Each number must be pressed within five seconds of each other. The keyless entry keypad will illuminate after pressing the first control on the keypad. To unlock all doors, press the 3 • 4 control within five seconds. To lock all doors, press the 7 • 8 and the 9 • 0 at the same time. You do not need to enter the keypad code first. Note: The interior lamps will turn off. 105 2007 Monterey (mty) Owners Guide (post-2002-fmt) USA (fus)