2007 Mercury Monterey Owner Guide 1st Printing - Page 61

Driver Controls desirable to prevent power operation of the door by rear seat passengers or if manual operation of the door is desired or necessary when the vehicle is stopped or parked on a steep downhill grade. Refer to the Manual operation of the sliding door section in this chapter for more information. With the child safety lock engaged, the inside handle operation will always be disabled regardless of the position of the Power Door Lockout control. Refer to the Sliding door child safety lock section in this chapter for more information. The trim mounted rear seat control and the outside handle remain functional for power operation. Safety/Obstructions If anything obstructs the Power Sliding Door while it is power closing or opening, the door will automatically reverse or stop depending on the position of the door, provided it meets sufficient resistance. Resetting the PSD The power sliding door may operate incorrectly or not at all because of the following conditions: • a low voltage or dead battery • the door is left opened for more than 6 hours • the battery is disconnected • the PSD Passenger compartment fuse panel fuse (fuse #11) is removed or blown. Refer to Fuses and relays in the Roadside Emergencies chapter. If any of the above conditions has occurred, perform the following steps to reset the PSD so that electronics can relearn the open and closed positions: 1. Check to see if PSD is securely closed. 2. Make sure the gearshift is in (P) Park. 3. Push the PSD control on the overhead console to open the door. 4. Wait five (5) seconds and close the door by pressing the PSD control on the overhead console. 5. Wait five (5) seconds and repeat Steps 3 and 4 then go on to Step 6. 6. Repeat Steps 3-5 for opposite door. If the door still does not operate correctly: 7. Ensure the ignition is in the OFF position 61 2007 Monterey (mty) Owners Guide (post-2002-fmt) USA (fus)