2009 Mercury Mariner Scheduled Maintenance Guide 1st Printing - Page 28

NORMAL SCHEDULE TRUCKS, FULLSIZE VANS & SUVS 150,000 miles ❑ Change engine oil and replace oil filter ❑ Change Motorcraft Premium Gold Engine Coolant (see Exceptions on page 47 and Premium Gold Coolant Change Record on page 48) Replace cabin air filter (if equipped) Replace climate-controlled seat filter (if equipped) Replace engine air filter Replace fuel filter (except Escape, Mariner, F-Series [non Super Duty], Expedition/Navigator [short wheel base only], E-Series) Change automatic transmission/transaxle fluid and filter (filter not required on 6F35). (Except vehicles equipped with the TorqShift transmission). Change manual transmission fluid (Escape) Change rear axle lubricant on all rear wheel drive (RWD) vehicles (see pages 42 and 47). Change transfer case fluid (4x4 only) Change front differential fluid (4x4 only) Replace wheel bearings (if non-sealed bearings) Replace accessory drive belt(s) if not replaced in the last 100,000 miles (160,000 km) Inspect steering linkage, ball joints, suspension, tie rod ends, driveshaft, and U-joints (lubricate if equipped with Zerk fittings) Inspect engine cooling system and hoses Inspect brake pads, shoes, rotors, drums, brake lines and hoses and parking brake system. Inspect half shaft boots (if equipped) Inspect exhaust system and heat shields Inspect PCV valve for flow (3V engines) Inspect and lubricate 4x4 front axle U-joints Rotate tires, inspect tires for wear and measure tread depth (vehicles with dual rear wheels should only rotate if unusual wear is noted) Inspect the wheels and related components for abnormal noise, wear, looseness, or drag Perform multi-point inspection (recommended) ❑ DEALER VALIDATION: RO#: DATE: P&A CODE: MILEAGE: 28 Scheduled Maintenance 2009 Scheduled Maintenance Guide (smg) Scheduled Maintenance Guide USA (fus)