1996 Nissan Quest Owner's Manual - Page 101
1996 Nissan Quest Manual
Page 101 highlights
4. Pull on the third row shoulder belt until all of the belt is fully extended and a click is heard. At this time, the belt retractor is in the automatic locking mode (child restraint mode). (The lap/shoulder belt reverts back to emergency locking mode when it is disconnected from the tether strap and fully retracted.) 5. Allow the belt to retract. A clicking sound is heard as the belt retracts. This indicates that the retractor is in the automatic locking mode. Tighten the tether strap to remove any slack. 6. Before placing the child in the child restraint, use force to tilt the child restraint from side to side, and tug it forward to make sure it is securely held in place. 7. Check that the retractor is in the automatic locking mode by trying to pull more belt out of the retractor. If you cannot pull any more belt webbing out of the retractor, the belt is in the automatic locking mode. 8. Check to make sure the child restraint is properly secured prior to each use. If the belt is not locking, repeat steps 4 through 7. Tethering to floor When installing a child restraint on the three-passenger bench seat in the third row position, first install the floor anchor bracket (found in the tool kit) to the provided anchor point. To gain access to an anchor point, cut along the U-shaped anchor point indicators on the floor carpeting of the luggage area. Installing the anchor bracket requires removing the bolt already installed at the anchor point and using a metric bolt of the dimensions listed below: Bolt diameter: 8.0 mm Bolt length: more than 1.18 in (30 mm) Thread pitch: 1.25 mm WARNING ● Bolts should be installed at all times to prevent the possibility of exhaust fumes entering the passenger compartment through the holes. ● Child restraint anchor points are designed to withstand only those loads imposed by correctly fitted child restraints. Under no circumstances are they to be used for adult seat belts or harnesses. APD0836 INSTALLATION ON THREEPASSENGER BENCH SEAT IN THIRD ROW A child restraint with a top tether strap may be placed on the three-passenger bench seat when the bench seat is in the third row location. Once the child restraint is properly secured to the seat (see ''Installation at second and third row outboard positions'' or ''Installation at three-passenger bench seat center position'' earlier in this section), follow the directions below to attach the tether strap to one of the anchor points. 2-68