1996 Nissan Quest Owner's Manual - Page 99
1996 Nissan Quest Manual
Page 99 highlights
APD0832 APD0833 APD0834 INSTALLATION ON SECOND ROW BENCH OR BUCKET SEAT A child restraint with a top tether strap may be placed on the second row bench or bucket seats. Once the child restraint is properly secured to the seat (see ''Installation at second and third row outboard positions'' earlier in this section), follow the directions below to attach the tether strap to the third row lap/shoulder belt tongue located on the same side of the vehicle as the child restraint. Tethering to lap/shoulder belt tongue To attach a tether strap to a third row lap/shoulder belt: 1. Route the tether strap under the head restraint and between the head restraint supports. 2. Hook the tether strap into the large hole on the tongue of the third row lap/shoulder belt (located near the upper and lower rear corners of the vehicle). 3. Adjust the tether strap until the hook is about one foot behind the seatback. 2-66 4. Pull on the third row shoulder belt until all of the belt is fully extended and a click is heard. At this time, the belt retractor is in the automatic locking mode (child restraint mode). (The lap/shoulder belt reverts back to emergency locking mode when it is disconnected from the tether strap and fully retracted.) 5. Allow the belt to retract. A clicking sound is heard as the belt retracts. This indicates that the retractor is in the automatic locking mode. Tighten the tether strap and remove any slack.