1997 Nissan Quest Owner's Manual - Page 16
1997 Nissan Quest Manual
Page 16 highlights
Key reminder chime The chime sounds if the driver's or passenger's door is opened while the key is left in the ignition switch. Remove the key and take it with you when leaving the vehicle. it may indicate a potential emission control problem. The malfunction indicator light will come on in one of two ways: 1. Malfunction indicator light on steady - An emission control system malfunction has been detected. Have the vehicle inspected by an authorized NISSAN dealer. You do not need to have your vehicle towed to the dealer. 2. Malfunction indicator light blinking - An engine misfire has been detected which may damage the emission control system. To reduce or avoid emission control system damage: ● do not drive at speeds above 45 MPH (72 km/h). ● avoid hard acceleration or deceleration. ● avoid steep uphill grades. ● if possible, reduce the amount of cargo being hauled or towed. The malfunction indicator light may stop blinking and come on steady. Have the vehicle inspected by an authorized NISSAN dealer. You do not need to have your vehicle towed to the dealer. 1-9 Light reminder chime A chime sounds when the driver's or passenger's door is opened if the headlight control switch is turned on (ignition switch is turned OFF). Turn the headlight control switch to OFF when you leave the vehicle. CAUTION Continued vehicle operation without having the emission control system checked and repaired as necessary could lead to poor driveability, reduced fuel economy, and possible damage to the emission control system, which may affect your warranty coverage. Some conditions may cause the malfunction indicator light to come on steady or blink. For example, running the vehicle out of fuel, which causes the engine to misfire, may cause the malfunction indicator light to come on steady or blink. If you suspect that you experienced such a condition, drive the vehicle to an authorized NISSAN dealer and have the vehicle inspected. Avoid any unnecessary diagnosis during the service by informing the dealer of the condition that may have occurred. Brake pad wear warning The disc brake pads have audible wear warnings. When a brake pad requires replacement, it makes a high pitched scraping sound when the vehicle is in motion whether or not the brake pedal is depressed. Have the brakes checked as soon as possible if the warning sound is heard. or Malfunction indicator light (MIL) If the malfunction indicator light comes on steady or blinks while the engine is running,