1998 Nissan Quest Owner's Manual - Page 116
1998 Nissan Quest Manual
Page 116 highlights
BATTERY REPLACEMENT If the batteries are removed for any reason other than replacement, perform step 4. ● An improperly disposed battery can hurt the environment. Always conform to local regulations for battery disposal. ● The multi-remote controller is waterresistant; however, if it does get wet, immediately wipe completely dry. ● The operational range of the multiremote controller extends to approximately 49 ft (15 m) from the vehicle. This range may vary with conditions. FCC Notice: Changes or modifications not expressly approved by the manufacturer for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules and RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation of the device. Pre-driving checks and adjustments 3-9 APD1031 Replace the two batteries as follows: 1. Remove the screw and open the lid. 2. Replace the batteries with new ones. Insert the batteries as illustrated above. Recommended batteries: Sanyo CR2016 or equivalent. 3. Close the lid securely and install the screw. 4. Press the button, then the button two or three times to check the multiremote controller operation.