2000 Nissan Pathfinder Owner's Manual - Page 124
2000 Nissan Pathfinder Manual
Page 124 highlights
display reappears. Once the sound quality is set to the desired level, press the AUDIO button repeatedly until the radio or cassette tape display appears. Clock operation: Pressing the CLOCK button alternates the clock and the radio/cassette tape options in the display. Radio/Cassette tape priority mode: In this mode, the radio station illuminates in the display during radio operation. During cassette tape operation, TAPE illuminates in the display. The frequency range and step have now been changed to the central/south American specification. FM-AM radio operation FM-AM band select: Push the FM⋅AM band select button to change from AM to FM reception. The FM stereo indicator, ST illuminates during FM stereo reception. When the stereo broadcast signal is weak, the radio automatically changes from stereo to monaural reception. TUNE (Tuning): SAA0260 Adjusting tone quality and speaker balance: To adjust BASS⋅TREB⋅FADER⋅BAL (Bass, Treble, Fader, Balance), press the AUDIO button until the desired mode (BAS, TRE, FAD or BAL) appears in the display. Press the or button to adjust Bass (BAS) and Treble (TRE) to the desired level. Use the or button to adjust Fader or Balance modes. Fader adjusts the sound level between the front and rear speakers and Balance (BAL) adjusts the sound level between the right and left speakers. After 10 seconds, the radio or cassette tape Frequency range and step change operations The frequency range and step of this radio can be changed to the central/south American specification. To change the frequency range and step, proceed as follows: 1. Turn the audio unit on. 2. Press and hold the station select buttons 3 and 4. 3. Press the manual tuning button " " while the station select buttons 3 and 4 are being pressed. "MW 530 kHz" is displayed. WARNING The radio should not be tuned while driving in order that full attention may be given to the driving operation. Push either manual tuning button . SEEK/SCAN tuning: Push the SEEK/SCAN tuning button for less than 1.5 seconds. SEEK tuning begins from low to high frequencies and stops at the next broadcasting station. Pushing the button Heater, air conditioner and audio systems or 4-15