2000 Nissan Pathfinder Owner's Manual - Page 197
2000 Nissan Pathfinder Manual
Page 197 highlights
AUTOMATIC TRANSMISSION FLUID CAUTION Be careful not to burn yourself, as the engine oil may be hot. 4. Wipe the engine oil filter mounting surface with a clean rag. Be sure to remove any old rubber gasket remaining on the mounting surface of the engine. 5. Coat the rubber gasket on the new filter with engine oil. 6. Screw in the oil filter until a slight resistance is felt, then tighten an additional 2/3 turn. 7. Start the engine and check for leakage around the oil filter. Correct as required. 8. Turn the engine off and wait several minutes. Check the oil level. Add engine oil if necessary. SDI0488 TEMPERATURE CONDITIONS FOR CHECKING The fluid level should be checked using the HOT range (L & H marks) on the dipstick at fluid temperatures between 122 and 176°F (50 and 80°C) after the vehicle has been driven approximately 5 minutes in urban areas after the engine is warmed up. The level can be checked at fluid temperatures between 86 and 122°F (30 and 50°C) using the COLD range on the dipstick for reference, after the engine is warmed up but before driving. However, the fluid level must be rechecked using the HOT range. 1. Park the vehicle on a level surface and set the parking brake. 2. Start the engine and then move the selector lever through each gear range, ending in P. 3. Check the fluid level with the engine idling. If the vehicle has been driven for a long time at high speeds, or in city traffic in hot weather, or if it is being used to pull a trailer, the fluid level cannot be read accurately. You should wait until the fluid has cooled down (about 30 minutes). 4. Remove the dipstick and wipe it clean with lint-free paper. WARNING ¼ When engine is running, keep hands, jewelry, and clothing away from any moving parts such as fan and drive belt. ¼ Automatic transmission fluid is poisonous and should be stored carefully in marked containers out of the reach of children. 8-10 Do-it-yourself