2001 Nissan Pathfinder Owner's Manual - Page 104
2001 Nissan Pathfinder Manual
Page 104 highlights
MULTI-REMOTE CONTROL SYSTEM It is possible to lock/unlock all doors and activate the panic alarm by using the remote controller from outside the vehicle. Before locking the doors, make sure the key is not left in the vehicle. The remote controller can operate at a distance of approximately 33 ft (10 m) from the vehicle. (The effective distance depends upon the conditions around the vehicle.) As many as four remote controllers can be used with one vehicle. For information concerning the purchase and use of additional remote controllers, contact your NISSAN dealer. The multi-remote controller will not function when: ¼ the battery is dead, ¼ the distance between the vehicle and the remote controller is over 33 ft (10 m). The panic alarm will not activate when the key is in the ignition switch. ¼ Do not allow the remote controller to become wet. ¼ Do not drop the remote controller. ¼ Do not strike the remote controller sharply against another object. ¼ Do not place the remote controller for an extended period in an area where temperatures exceed 140°F (60°C). If a multi-remote controller is lost or stolen, NISSAN recommends erasing the ID code of that controller. This will prevent the controller from unauthorized use to unlock the vehicle. For information regarding the erasing procedure, please contact an authorized NISSAN dealer. In hazard indicator and horn mode, when the LOCK button is pushed, the hazard indicator flashes twice and the horn chirps once. When the UNLOCK button is pushed, the hazard indicator flashes once. If hazard indicator and horn mode is not necessary, you can switch to hazard indicator only mode by following the switching procedure below. In hazard indicator only mode, when the LOCK button is pushed, the hazard indicator flashes twice. When the UNLOCK button is pushed, neither the hazard indicator nor the horn operates. (Switching procedure) Press and hold the LOCK and UNLOCK buttons on the multi-remote controller simultaneously for at least 2 seconds to switch from one mode to the other. When pushing the buttons to set hazard indicator only mode, the hazard indicator flashes 3 times. When pushing the buttons to set hazard indicator and horn mode, the hazard indicator flashes once and the horn chirps once. HOW TO USE MULTI-REMOTE CONTROL SYSTEM Setting hazard indicator and horn mode This vehicle is set in hazard indicator and horn mode when you first receive the vehicle. CAUTION The following conditions or occurrences will damage the remote controller. Pre-driving checks and adjustments 3-5