2001 Nissan Pathfinder Owner's Manual - Page 191

PUSH STARTING to Neutral position (On automatic transmission models, move the selector lever to P (Park)). Switch off all unnecessary electrical systems (light, heater, air conditioner, etc.). 3. Remove vent caps on the battery (if so equipped). Cover the battery with an old cloth to reduce explosion hazard. 4. Connect jumper cables in the sequence as illustrated. at about 2,000 rpm, and start your engine in the normal manner. CAUTION ¼ Automatic transmission models cannot be push started. This may cause transmission damage. ¼ Three way catalyst equipped models should not be started by pushing since the three way catalyst may be damaged. ¼ Never try to start the vehicle by towing it; when the engine starts, the forward surge could cause the vehicle to collide with the tow vehicle. CAUTION Do not keep starter motor engaged for more than 10 seconds. If the engine does not start right away, turn the key off and wait 3 to 4 seconds before trying again. 7. After starting your engine, carefully disconnect the negative cable and then the positive cable. 8. Replace the vent caps (if so equipped). Be sure to dispose of the cloth used to cover the vent holes as it may be contaminated with corrosive acid. CAUTION ¼ Always connect positive (+) to positive (+) and negative (−) to body ground, (for example, strut mounting bolt, engine lift bracket, etc. - not to the battery). ¼ Make sure that cables do not touch moving parts in the engine compartment and that clamps do not contact any other metal. 5. Start the engine of the other vehicle and let it run for a few minutes. 6. Keep the engine speed of the other vehicle 6-10 In case of emergency