2005 Nissan Frontier Owner's Manual - Page 103
2005 Nissan Frontier Manual
Page 103 highlights
- do not drive at speeds above 45 MPH (72 km/h). - avoid hard acceleration or deceleration. - avoid steep uphill grades. - if possible, reduce the amount of cargo being hauled or towed. The malfunction indicator light may stop blinking and come on steady. Have the vehicle inspected by a NISSAN dealer. You do not need to have your vehicle towed to the dealer. See "Driving the vehicle" in the "Starting and driving" section of this manual. Security indicator light (if so equipped) This light blinks whenever the ignition switch is in the LOCK, OFF or ACC position. This function indicates the security system equipped on the vehicle is operational. For additional information, see "Security systems" later in this section. operational. If the light does not come on or does not go off, have the traction control system checked by a NISSAN dealer. If the battery is removed or discharged, the traction control system is disabled and the slip indicator light will not turn off after 2 seconds when the ignition switch is turned to the ON position. To reset the system, you must perform the reset procedure. Refer to "Vehicle dynamic control (VDC) system" in the "Starting and driving" section of this manual. If the light does not go off after performing the reset procedure, have the traction control system checked by a NISSAN dealer. CAUTION Continued vehicle operation without having the emission control system checked and repaired as necessary could lead to poor driveability, reduced fuel economy, and possible damage to the emission control system. Slip indicator light for models with ABLS (if so equipped) This indicator light comes on if the active brake limited slip is activated. If activated, the system will apply braking to the slipping drive wheel(s), giving the non-slipping wheel(s) more traction. Transfer 4LO position model) indicator light ( The light should turn off within 1 second after turning the ignition switch to ON. This light comes on when the 4WD shift switch is set in the 4LO position with the ignition key in the ON position. The transfer case may be damaged if you shift the switch while driving. Make sure the transfer 4LO position indicator light turns on when you shift the 4WD shift switch to 4LO. Overdrive off indicator light (automatic transmission models only) This light comes on when the overdrive function is OFF. The automatic transmission overdrive function is controlled by the overdrive switch. Slip indicator light for models with VDC (if so equipped) This indicator light will blink when the traction control system is limiting wheel spin. Slippery road conditions may exist if the slip indicator blinks on. If this happens, adjust your driving accordingly. The slip indicator light also comes on when you turn the ignition key to the ON position. The light will turn off after about 2 seconds if the system is Instruments and controls 2-19