2005 Nissan Frontier Owner's Manual - Page 47

7. Check that the retractor is in the automatic locking mode by trying to pull more seat belt out of the retractor. If you cannot pull any more seat belt webbing out of the retractor, the retractor is in the automatic locking mode. 8. Check to make sure that the child restraint is properly secured prior to each use. If the belt is not locked, repeat steps 3 through 7. After the child restraint is removed and the seat belt fully retracted, the automatic locking mode (child restraint mode) is canceled. LRS0547 5 LRS0548 6 Rear Facing - step 5 Allow the seat belt to retract. Pull up on the shoulder belt to remove any slack in the belt. Rear Facing - step 6 Before placing the child in the child restraint, use force to push the child restraint from side to side, and tug it forward to make sure that it is securely held in place. It should not move more than 1 inch (25 mm). If it does move more than 1 inch (25 mm), pull again on the shoulder belt to further tighten the child restraint. If unable to properly secure the restraint move the restraint to another seating position and try again , or try a different child restraint. Not all child restraints fit in all types of vehicles. CHILD RESTRAINT INSTALLATION ON REAR BENCH SEAT (Crew cab models only) WARNING ● The three-point seat belt in your vehicle is equipped with an automatic locking mode retractor which must be used when installing a child restraint. ● Failure to use the retractor's locking mode will result in the child restraint not being properly secured. The restraint could tip over or otherwise be unsecured and cause injury to the child in a sudden stop or collision. Safety-Seats, seat belts and supplemental restraint system 1-29