2005 Nissan Xterra Owner's Manual - Page 79

2005 Nissan Xterra Manual

Get 2005 Nissan Xterra PDF manuals and user guides View all 2005 Nissan Xterra manuals

Page 79 highlights

TRIP COMPUTER (if so equipped) The display of the trip computer is situated in the speedometer display. When the ignition is turned to ON, the display scrolls all the modes of the trip computer and then shows the mode chosen before the ignition switch was turned OFF. When the ignition switch is turned to ON, modes of the trip computer can be selected by pushing the trip computer change button. The following modes can be selected: NOTE: ● If the amount of fuel added while the ignition switch is OFF is small, the display just before the ignition switch is turned OFF may continue to be displayed. ● When driving uphill or rounding curves, the fuel in the tank shifts, which may momentarily change the display. Distance to empty (dte-mile or km) LIC0781 Average speed (MPH or km/h) The average speed mode shows the average vehicle speed since last reset. Resetting is done by pressing the change button for more than approximately 1 second. The display is updated every 30 seconds. The first 30 seconds after a reset, the display shows (----). With trip computer For vehicles equipped with trip computer, pushing the change button changes the display as follows: Trip → Trip → Distance to Empty → Average speed → Average fuel consumption → Journey time → Trip For additional information, refer to "Trip computer" later in this section. Resetting the trip odometer: Pushing the change button for more than 1 second resets the trip odometer to zero. The distance to empty (dte) mode provides you with an estimation of the distance that can be driven before refueling. The dte is constantly being calculated, based on the amount of fuel in the fuel tank and the actual fuel consumption. The display is updated every 30 seconds. The dte mode includes a low range warning feature: when the fuel level is low, the dte mode is automatically selected and the digits blink in order to draw the driver's attention. Press the change button if you wish to return to the mode that was selected before the warning occurred. The dte mark (dte) will remain blinking until the vehicle is refueled. When the fuel level drops even lower, the dte display will change to (----). Average fuel consumption (Mpg or l/100km) The average fuel consumption mode shows the average fuel consumption since the last reset. Resetting is done by pressing the change button for more than approximately 1 second. The display is updated every 30 seconds. At about the first 1/3 miles (500 m) after a reset, the display shows (----). Instruments and controls 2-5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
  • 197
  • 198
  • 199
  • 200
  • 201
  • 202
  • 203
  • 204
  • 205
  • 206
  • 207
  • 208
  • 209
  • 210
  • 211
  • 212
  • 213
  • 214
  • 215
  • 216
  • 217
  • 218
  • 219
  • 220
  • 221
  • 222
  • 223
  • 224
  • 225
  • 226
  • 227
  • 228
  • 229
  • 230
  • 231
  • 232
  • 233
  • 234
  • 235
  • 236
  • 237
  • 238
  • 239
  • 240
  • 241
  • 242
  • 243
  • 244
  • 245
  • 246
  • 247
  • 248
  • 249
  • 250
  • 251
  • 252
  • 253
  • 254
  • 255
  • 256
  • 257
  • 258
  • 259
  • 260
  • 261
  • 262
  • 263
  • 264
  • 265
  • 266
  • 267
  • 268
  • 269
  • 270
  • 271
  • 272
  • 273
  • 274
  • 275
  • 276
  • 277
  • 278
  • 279
  • 280
  • 281
  • 282
  • 283
  • 284
  • 285
  • 286
  • 287
  • 288
  • 289
  • 290
  • 291
  • 292
  • 293
  • 294
  • 295
  • 296
Forvehiclesequippedwithtripcomputer,push-
ing the change button changes the display as
follows:
Trip
→
Trip
→
DistancetoEmpty
→
Average speed
→
Average fuel consumption
→
Journeytime
→
Trip
For additional information, refer to “Trip com-
puter”laterinthissection.
Resettingthetripodometer:
Pushingthechangebuttonformorethan1sec-
ondresetsthetripodometertozero.
TRIPCOMPUTER(ifsoequipped)
Thedisplayofthetripcomputerissituatedinthe
speedometerdisplay.Whentheignitionisturned
toON,thedisplayscrollsallthemodesofthetrip
computerandthenshowsthemodechosenbe-
foretheignitionswitchwasturnedOFF.
WhentheignitionswitchisturnedtoON,modes
ofthetripcomputercanbeselectedbypushing
the trip computer change button. The following
modescanbeselected:
Distancetoempty(dte—mileorkm)
The distance to empty (dte) mode provides you
with an estimation of the distance that can be
drivenbeforerefueling.Thedteisconstantlybe-
ingcalculated,basedontheamountoffuelinthe
fueltankandtheactualfuelconsumption.
Thedisplayisupdatedevery30seconds.
The dte mode includes a low range warning
feature:whenthefuellevelislow,thedtemodeis
automatically selected and the digits blink in or-
der to draw the driver’s attention. Press the
change button if you wish to return to the mode
that was selected before the warning occurred.
The dte mark (dte) will remain blinking until the
vehicleisrefueled.
When the fuel level drops even lower, the dte
displaywillchangeto(----).
NOTE:
●
If the amount of fuel added while the
ignitionswitchisOFFissmall,thedis-
play just before the ignition switch is
turned OFF may continue to be dis-
played.
●
Whendrivinguphillorroundingcurves,
the fuel in the tank shifts, which may
momentarilychangethedisplay.
Averagespeed(MPHorkm/h)
The average speed mode shows the average
vehiclespeedsincelastreset.Resettingisdone
by pressing the change button for more than
approximately 1 second. The display is updated
every 30 seconds. The first 30 seconds after a
reset,thedisplayshows(----).
Averagefuelconsumption(Mpgor
l/100km)
The average fuel consumption mode shows the
average fuel consumption since the last reset.
Resettingisdonebypressingthechangebutton
for more than approximately 1 second. The dis-
play is updated every 30 seconds. At about the
first 1/3 miles (500 m) after a reset, the display
shows(----).
Withtripcomputer
LIC0781
Instruments and controls
2-5