2006 Nissan Quest Owner's Manual - Page 167
2006 Nissan Quest Manual
Page 167 highlights
To automatically display the Maintenance menu ("ENGINE OIL" and "TIRE ROTATION") when the vehicle is driven the set distance, turn ON the service alert key. To turn the service alert key ON, refer to "How to use the setting button" later in this section". When the vehicle is driven the set distance, the MAINTENANCE screen will be automatically displayed and the Maintenance menu ("ENGINE OIL" and "TIRE ROTATION") will blink. To return to the previous display after the "MAINTENANCE NOTICE" message is displayed, push the PREV button. The "MAINTENANCE NOTICE" screen displays each time the ignition key is turned ON until one of the following conditions are met: ● button or "TRIP RESET" button is pushed. LHA0250 LHA0383 HOW TO USE BUTTON (maintenance) Tire pressure information Pressure indication in **psi on the screen indicates that the pressure is being measured. After a few driving trips, the pressure for each tire will be displayed randomly. The order of the tire pressure figures displayed on the screen does not correspond with the actual order of the tire position. Tire pressure rises and falls depending on the heat caused by the vehicle's operation and the outside temperature. Pushing the button will change the maintenance menu as follows: ENGINE OIL → TIRE ROTATION→ TIRE PRESSURE To reset the driving distance, push the button or "TRIP RESET" button for more than approximately 1.5 seconds. To set the distance, push the joystick to left or right. ● "Service alert key" is set OFF. ● the maintenance interval is set again. Display screen, heater, air conditioner and audio systems 4-5