2006 Nissan Quest Owner's Manual - Page 179

6. DEST button* 7. ROUTE button* 8. MAP button* 9. GUIDE VOICE button* 10. 11. zoom in button* zoom out button* SETTING UP THE START-UP SCREEN When you turn the ignition key to ACC or ON, the SYSTEM START-UP warning is displayed on the screen. Read the warning and select the "I AGREE" (English) or "ENTER" (Français) key then push the "ENTER" button. If you do not push the "ENTER" button, the Navigation system will not proceed to the next step display. If you do not touch a button or screen key for more than 1 minute on the START-UP screen, the screen will change to the map display screen automatically. To proceed to the next step, refer to the separate Navigation System Owner's Manual. HOW TO USE JOYSTICK AND "ENTER" BUTTON Choose an item on the display using the joystick and push the "ENTER" button for operation. HOW TO USE "BACK" BUTTON This button has two functions. ● Go back to the previous display (cancel). If you press the "BACK" button during setup, the setup will be canceled and/or the display will return to the previous screen. ● Finish setup. If you press this button after the setup is completed, the setup will start over, and the display will return to the climate control or audio mode and Navigation screen. LHA0552 HOW TO USE THE "TRIP" BUTTON When the "TRIP" button is pushed, the following modes will display on the screen. Warning message (if there are any) → TRIP 1 (Elapsed Time, Driving Distance, Average Speed) → TRIP 2 → FUEL ECONOMY (Average Fuel Economy, Distance to Empty) → MAINTENANCE (Engine Oil, Tire Rotation and Tire Pressure - if so equipped) → OFF → TRIP 1. Display screen, heater, air conditioner and audio systems 4-17