2008 Nissan Altima Owner's Manual - Page 236
2008 Nissan Altima Manual
Page 236 highlights
PUSH-BUTTON IGNITION SWITCH The ignition switch is equipped with an anti-theft steering lock device. The ignition lock is designed so that the ignition switch position cannot be switched to OFF until the selector lever is moved to the P (Park) position (CVT) or N (Neutral) position (MT). When the ignition switch cannot be pushed toward the OFF position, proceed as follows: 1. Move the selector lever into the P (Park) position (CVT) or N (Neutral) position (MT). 2. Push the ignition switch. The ignition switch position will change to the ON position. 3. Push the ignition switch again to the OFF position. The selector lever can be moved from the P (Park) position if the ignition switch is in the ON position and the brake pedal is depressed. In order for the steering wheel to be locked, it must be turned about 1/8 of a right or left turn from the straight up position. To lock the steering wheel, push the ignition switch to the LOCK position. To unlock the steering wheel, push the ignition switch while slightly turning the steering wheel right and left. WARNING Do not operate the push-button ignition switch while driving the vehicle except in an emergency. (The engine will stop when the ignition switch is pushed 3 consecutive times in quick succession or the ignition switch is pushed and held for more than 2 seconds.) If the engine stops while the vehicle is being driven, this could lead to a crash and serious injury. WSD0196 When the ignition switch is pushed without depressing the brake pedal (CVT) or the clutch pedal (MT), the ignition switch position will illuminate as follows: Push center ● once to change to ACC. ● two times to change to ON. ● three times to return to OFF. The ignition switch will automatically return to the LOCK position when any door is either opened or closed with the switch in the OFF position. 5-6 Starting and driving