2008 Nissan Rogue Owner's Manual - Page 81

WARNING

.

If the light does not illuminate with

the ignition switch turned ON, have

the vehicle checked by a NISSAN

dealer as soon as possible.

.

If the light illuminates while driving,

avoid sudden steering maneuvers or

abrupt

braking,

reduce

vehicle

speed, pull off the road to a safe

location

and

stop

the

vehicle

as

soon as possible. Driving with un-

der-inflated tires may permanently

damage the tires and increase the

likelihood

of

tire

failure.

Serious

vehicle

damage

could

occur

and

may lead to an accident and could

result

in

serious

personal

injury.

Check the tire pressure for all four

tires. Adjust the tire pressure to the

recommended COLD tire pressure

shown

on

the

Tire

and

Loading

Information label to turn the low

tire pressure warning light OFF. If

the light stays on after adjusting the

tire pressure

and driving over 16

MPH (25 km/h), have the system

checked by a NISSAN dealer. If you

have a flat tire, replace it with a

spare tire as soon as possible.

.

When a spare tire is mounted or a

wheel is replaced, the TPMS will not

function and the low tire pressure

warning light will flash for approxi-

mately

1

minute.

The

light

will

remain on after the 1 minute. Con-

tact your NISSAN dealer as soon as

possible for tire replacement and/or

system resetting.

.

Replacing tires with those not ori-

ginally specified by NISSAN could

affect the proper operation of the

TPMS.

CAUTION

.

The TPMS is not a substitute for the

regular tire pressure check. Be sure

to check the tire pressure regularly.

.

If

the

vehicle

is

being

driven

at

speeds

of less than 16

MPH (25

km/h), the TPMS may not operate

correctly.

.

Be sure to install the specified size

of tires to the front and rear.

Low washer fluid warning light (if

so equipped)

This light illuminates when the washer fluid is at

a low level. Add washer fluid as necessary. (See

“WINDOW WASHER FLUID” in the “8. Main-

tenance and do-it-yourself” section.)

P position selecting warning light

(if so equipped)

The light blinks in red and warning buzzer beeps

when the selector lever is not in the P (Park)

position and you are outside the vehicle with the

Intelligent Key.

When the warning light blinks, move the selector

lever to the P (Park) position and return the

ignition switch to the LOCK position.

See “INTELLIGENT KEY SYSTEM” in the “3.

Pre-driving checks and adjustments” section.

Seat belt warning light

The light and chime remind you to fasten seat

belts. The light illuminates whenever the ignition

switch is turned to the ON position, and will

remain illuminated until the driver’s seat belt is

fastened. At the same time, the chime will sound

for about 6 seconds unless the driver’s seat belt

is securely fastened.

Instruments and controls

2-15

2008 Nissan Rogue Owner's Manual - Page 81

2008 Nissan Rogue Manual

Page 81 highlights