2009 Nissan Frontier King Cab Owner's Manual - Page 246
2009 Nissan Frontier King Cab Manual
Page 246 highlights
ACTIVE BRAKE LIMITED SLIP (ABLS) SYSTEM When the ABS senses that one or more wheels are close to locking up, the system electronically controls the pressure applied to each brake. This action is similar to pumping the brakes very quickly. You may feel a pulsation in the brake pedal and hear a noise from under the hood or feel a vibration from the actuator when it is operating. This is normal and indicates that the ABS is operating properly. However, the pulsation may indicate that road conditions are hazardous and extra care is required while driving. ● ABLS is a form of traction control using sensors from the Anti-lock Brake System (ABS) to transfer power from a slipping drive wheel to a wheel with more traction. The ABLS system applies braking to the slipping wheel, which helps redirect power to another wheel. ● On 4WD models the ABLS system operates in both 4H and 4LO modes. If 4WD mode is engaged, the ABLS system will operate for both drive axles. On 2WD vehicles, the ABLS system operates on the drive axle only. ● The ABLS system is always ON unless the system detects brake pad overheating. If high brake pad temperature is detected, it will turn OFF, but normal brake function will continue. ABLS will function even when the VDC system is turned OFF. VEHICLE DYNAMIC CONTROL (VDC) SYSTEM (if so equipped) The Vehicle Dynamic Control (VDC) system uses various sensors to monitor driver inputs and vehicle motion. Under certain driving situations, the system will control braking and engine output to help keep the vehicle on its steered path. ● When the Vehicle Dynamic Control (VDC) system is operating, the SLIP indicator in the instrument panel blinks. ● If the 4WD transfer case is shifted into 4LO indicator light will come on and the the VDC system will be turned off. See "Transfer case shifting procedures" earlier in this section. ● If the SLIP indicator blinks, the road conditions may be slippery. Be sure to adjust your speed and driving to these conditions. See "Slip indicator light", and "Vehicle Dynamic Control (VDC) off indicator light" in the "Instruments and controls" section. If the battery is removed or discharged, the traction control system may be disabled and the SLIP and indicator lights will not turn off after 2 seconds when the ignition switch is turned to the ON position. Perform the following procedure to reset the system: ● Start the engine and set the steering wheel in the straight forward position. WARNING The ABLS system provides increased traction, but will not prevent accidents due to abrupt steering operation or by careless driving or dangerous driving practices. Reduce vehicle speed and be especially careful when driving and cornering on slippery surfaces, and always drive carefully. 5-34 Starting and driving