2009 Nissan Frontier King Cab Owner's Manual - Page 56

7. Check that the retractor is in the ALR mode by trying to pull more seat belt out of the retractor. If you cannot pull any more seat belt webbing out of the retractor, the retractor is in the ALR mode. 8. Check to make sure that the child restraint is properly secured prior to each use. If the seat belt is not locked, repeat steps 3 through 7. After the child restraint is removed and the seat belt fully retracted, the ALR mode (child restraint mode) is canceled. ● Failure to use the ALR mode will result in the child restraint not being properly secured. The restraint could tip over or otherwise be unsecured and cause injury to the child in a sudden stop or collision. CHILD RESTRAINT INSTALLATION USING THE SEAT BELTS - PASSENGER'S SIDE JUMP SEAT (King cab models only) WARNING ● The three-point seat belt in your vehicle is equipped with an Automatic Locking Retractor (ALR) which must be used when installing a child restraint. LRS0598 WARNING ● When installing a child restraint system in the passenger's side jump seat position be sure to unfold the seat extension on the jump seat. If the jump seat extension is not properly used, the child restraint will not be installed correctly and the child could be injured in a collision or sudden stop. ● Never install a child restraint on the driver's side jump seat. A child restraint can not be properly installed in the driver's side jump seat and the child could be injured in a collision or sudden stop. 1-38 Safety-Seats, seat belts and supplemental restraint system