2010 Nissan Frontier Crew Cab Owner's Manual - Page 164

NOTE: Use care when rotating extender, buckles may come in contact with the truck bed railing. Removing and installing the bed extender To remove or install the bed extender perform the following: 1. Open the tailgate. 2. Rotate the bed extender into a vertical position and lift straight up (to remove) or lower straight down (to install). To store the bed extender in the front of the truck when not in use perform the following: 1. Position the sliding brackets past the center of the wheel well. 2. Re-install the extender into the brackets (see above). 3. Rotate the extender to the inward position. 4. Push the brackets forward until the extender comes in contact with the front wall of the truck box. LPD0479 LTI0102 To use the bed extender in the outward position perform the following: 1. Open the tailgate. 2 away from the 2. Rotate the bed extender ᭺ cab of the truck until the extender sits on the tailgate. TIE DOWN HOOKS (if so equipped) For your convenience, tie down hooks are placed at each corner of the truck box. These may be used to help secure cargo loaded into the truck box. ● The weight of the cargo load must be evenly distributed over both the front and the rear axles. ● All cargo should be securely fastened with ropes or straps to prevent it from shifting or sliding within the vehicle. 3. Lock the buckles ᭺ into the tailgate latch. 3 The bed extender can be adjusted in the outward position by moving the extender along the rail. 3-18 Pre-driving checks and adjustments