2010 Nissan Frontier Crew Cab Owner's Manual - Page 293

5-SPEED AUTOMATIC TRANSMISSION FLUID 7. Coat the gasket on the new filter with clean engine oil. 8. Screw on the oil filter until a slight resistance is felt, then tighten an additional 2/3 turn. 9. Start the engine and check for leakage around the oil filter. Correct as required. 10. Turn the engine off and wait more than 10 minutes. Check the oil level. Add engine oil if necessary. When checking or replacement is required, we recommend your NISSAN dealer for servicing. POWER STEERING FLUID CAUTION ● Use Genuine NISSAN Matic S ATF. If Genuine NISSAN Matic S ATF is not available, Genuine NISSAN Matic J ATF may also be used. ● Using automatic transmission fluid other than Genuine NISSAN Matic S ATF or Matic J ATF will cause deterioration in driveability and automatic transmission durability, and may damage the automatic transmission, which is not covered by the NISSAN new vehicle limited warranty. The specified automatic transmission fluid is also described on caution labels located in the engine compartment. WDI0256 The fluid level should be checked using the HOT MAX range on the power steering fluid reservoir at fluid temperatures of 122° - 176°F (50° 80°C) or using the COLD MAX range on the power steering fluid reservoir at fluid temperatures of 32° - 86°F (0° - 30°C). If the fluid is at or below the MIN line, add Genuine NISSAN PSF. Remove the cap and fill through the opening. CAUTION ● DO NOT OVERFILL. ● Recommended fluid is NISSAN PSF or equivalent. Genuine Maintenance and do-it-yourself 8-13