2010 Nissan Murano Owner's Manual - Page 268

"Select Ring tone" Use the Select Ring tone command to select the tone heard in the vehicle when an incoming call is received. The system announces the name of the active phone and asks you to choose from the following commands: . "Ringtone" - The system plays a ringtone and asks if you would like to select that tone. If you say no, the system plays the next ringtone available and continues to cycle through the ringtones until you select one or quit. "Silent" - The system asks you to confirm your wish to disable the ringtone. memory locations are in use, the system will ask the user to select which memory location should be overwritten. 9. When training is finished, the system will tell you an adequate number of phrases have been recorded. 10. The system will ask you to say your name. Follow the instructions to register your name. 11. The system will announce that speaker adaptation has been completed and the system is ready. The SA mode will stop if: ...The button is pressed for more than 5 seconds in SA mode. The vehicle is driven during SA mode. The ignition switch is pushed to the OFF or LOCK position. Training procedure The procedure for training a voice is as follows. 1. Position the vehicle in a reasonably quiet outdoor location. 2. Sit in the driver's seat with the engine running, the parking brake on, and the transmission in the P (Park) position. 3. Press and hold the than 5 seconds. button for more . SPEAKER ADAPTATION (SA) MODE Speaker Adaptation allows up to two out-of dialect users to train the system to improve recognition accuracy. By repeating a number of commands, the users can create a voice model of their own voice that is stored in the system. The system is capable of storing a different speaker adaptation model for memory A and memory B. If memory A is available, the system will use memory A to store the model. If memory A is in use and memory B is available, the system will use memory B to store the model. If both of the 4. The system announces: "Press the PHONE/ SEND ( ) button for the hands-free phone system to enter the speaker adaptation mode". 5. Press the button. Training phrases During the SA mode, the system instructs you to say the following phrases. (The system will prompt you for each phrase.) ...phone book new entry dial three oh four two nine delete call back number setup pair phone memo pad play 6. Voice memory A or memory B is selected automatically. If both memory locations are already in use, the system will prompt you to overwrite one. Follow the instructions provided by the system. 7. When preparation is complete and you are button. ready to begin, the press the 8. The SA mode will be explained. Follow the instructions provided by the system. 4-96 Monitor, heater, air conditioner, audio, phone and voice recognition systems