2012 Nissan Pathfinder Owner's Manual - Page 139

● position the hand-held transmitter 1 - 3 inches (26 - 76 mm) away from the HomeLinkா surface. Hold the transmitter in that position for up to 15 seconds. If HomeLinkா is not programmed within that time, try holding the transmitter in another position - keeping the indicator light in view at all times. If you continue to have programming difficulties, please contact the NISSAN Consumer Affairs Department. The phone numbers are located in the Foreword of this manual. 2. When the indicator light begins to flash slowly (after 20 seconds), position the hand-held transmitter 1 - 3 inches (26 - 76 mm) away from the HomeLinkா surface. 3. Press and hold the hand-held transmitter button. 4. The HomeLinkா indicator light will flash, first slowly and then rapidly. When the indicator light begins to flash rapidly, release both buttons. The HomeLinkா Universal Transceiver button has now been reprogrammed. The new device can be activated by pushing the HomeLinkா button that was just programmed. This procedure will not affect any other programmed HomeLinkா buttons. FCC Notice: For USA: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. For Canada: This device complies with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. CLEARING THE PROGRAMMED INFORMATION Individual buttons cannot be cleared. However, to clear all programming, press and hold the two outside buttons and release when the indicator light begins to flash (approximately 20 seconds). IF YOUR VEHICLE IS STOLEN If your vehicle is stolen, you should change the codes of any non-rolling code device that has been programmed into HomeLinkா. Consult the Owner's Manual of each device or call the manufacturer or dealer of those devices for additional information. When your vehicle is recovered, you will need to reprogram the HomeLinkா Universal Transceiver with your new transmitter information. REPROGRAMMING A SINGLE HOMELINKா BUTTON To reprogram a HomeLinkா Universal Transceiver button, complete the following. 1. Press and hold the desired HomeLinkா button. Do not release the button until step 4 has been completed. 2-54 Instruments and controls