2013 Nissan cube Quick Reference Guide - Page 8

first d ri v e f e a t u r e s FOLDING DOWN THE REAR BENCH SEAT To fold the seats flat, secure the seat belts on the seat belt hooks on the side wall. Release the connector tongue of the rear center seat belt from the buckle, then store the connector and seat belt tongues on the seat belt hook. Before folding down the seatback, tuck the seat belt buckles into the seat cushion pockets. Fold the seatback down by pulling the adjusting strap 01 . To raise the seatback, lift up each seatback and push it to the upright position until it is latched. After raising the seatback, pull the seat belt buckles out of the seat cushion pockets until they are fully extended before using the seat belts. For more information, refer to the "Safety - Seats, seat belts and supplemental restraint system (section 1)" of your Owner's Manual. 01 OUTSIDE MIRROR CONTROL SWITCH The outside mirror control switch is located on the left side of the instrument panel. To select the left or right mirror, move the switch 01 . Adjust each mirror to the desired position using the switch 02 . To prevent accidentally moving the mirror, move this switch 01 to the center "neutral" position. For more information, refer to the "Pre-driving checks and adjustments (section 3)" of your Owner's Manual. 01 02 STARTING/STOPPING THE ENGINE CONTINUOUSLY VARIABLE TRANSMISSION (NISSAN Intelligent Key® models only - if so equipped) Depress the brake pedal. Move the shift lever to the P (PARK) position. Push the ignition switch to start the engine. NOTE: It is important to make sure the Intelligent Key is with you (that is, in your pocket or purse). TURNING THE ENGINE OFF Move the shift lever to the P (PARK) position, apply the parking brake and push the ignition switch. 6 To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.