2004 Polaris Sportsman 700 Owners Manual - Page 98
2004 Polaris Sportsman 700 Manual
Page 98 highlights
Lights MAINTENANCE AND LUBRICATION High Beam Adjustment The headlight beam can be adjusted to any position desired by turning the adjusting knob on the bottom right side of the headlight pod. 1. Position the vehicle on a level surface with the headlight approximately 25 ft. (7.6 m) from a wall. 2. Measure the distance from the floor to the center of the headlight and make a mark on the wall at the same height. 3. Start the engine and turn the headlight switch to high beam. 4. Observe the headlight aim on the wall. The most intense part of the headlight beam should be aimed two inches (5.1 cm) below the mark placed on the wall. NOTE: Include rider weight on the seat when measuring. 5. Adjust the beam to the desired position by turning the adjustment knob either clockwise or counterclockwise. Snap pins into tabs Position knob in slot and secure in locking tabs Adjustment Knob Stop Route plug over handlebar 95