2006 Polaris Ranger XP 700 EFI 4x4 Owners Manual - Page 99

MAINTENANCE AND LUBRICATION Cleaning and Storage Storage Tips CAUTION Starting the engine during the storage period will disturb the protective film created by fogging and damage could occur. Never start the engine during the storage period. Clean the Exterior Make necessary repairs and then clean the vehicle thoroughly with mild soap and warm water to remove all dirt and grime. Don't use harsh detergents or high pressure washers. Some detergents deteriorate rubber parts. Use dish soap type cleaners only. High pressure washers may force water past seals. Stabilize the Fuel Fill the fuel tank. Add Polaris Carbon Clean Fuel Treatment or Polaris Fuel Stabilizer. Follow the instructions on the container for the recommended amount. (Carbon clean will also reduce the possibility of bacterial growth in the fuel system.) Allow 15-20 minutes of operation for the stabilizer to disperse through the fuel in the tank. Oil and Filter Warm the engine and change the oil and filter. Air Filter / Air Box / Breather Filter Inspect and clean or replace the pre-cleaner and air filter. Clean the air box and drain the sediment tube. Fluid Levels Inspect the following fluid levels and change if necessary: front and rear gearcases; transmission and brake fluid (change every two years or as required if fluid looks dark or contaminated). Inspect and Lubricate Inspect all cables and lubricate. Follow lubrication guidelines in the Maintenance Section of the service or owner's manual to completely grease and lubricate the entire vehicle with Polaris Premium All Season Grease. 96