2004 Pontiac Montana Owner's Manual - Page 182
2004 Pontiac Montana Manual
Page 182 highlights
Mode 3: Standard Arming and Disarming • The system will arm when you lock the doors using either power door lock switch while any door or the liftgate is open and the key is removed from the ignition. 3. Press the button with the horn symbol on the remote keyless entry transmitter. 4. Count the number of chimes you hear. The number of chimes indicates the vehicle's current programmed mode. If you do not wish to change the current mode, you can either exit the programming mode by following the instructions later in this section or program the next feature available on your vehicle. 5. Press the panic button to change the current mode. 6. Press the panic button until you hear the number of chimes corresponding to the mode selection you want. 7. Remove your key from the door key cylinder. The mode you selected is now set. You can either exit the programming mode by following the instructions next in this section or program the next feature available on your vehicle. • The system will arm when you lock the doors with your key or remote keyless entry transmitter and the key is removed from the ignition. • The system will disarm when you unlock the doors with your key or remote keyless entry transmitter. Your vehicle was originally programmed to Mode 1. The mode may have been changed since then. To determine the current mode, or to change the mode, do the following: 1. Follow the instructions for Entering Programming Mode on page 2-60. 2. Insert your spare key fully into any door key cylinder and turn it to the unlock position. This step is necessary to prevent accidental programming of this feature to Mode 2. Do not program this feature to Mode 2 without first reading Mode 2 entirely. The door key cylinder must remain in the unlock position during Steps 2 through 4. Exiting Programming Mode To exit programming mode, turn the key from ACCESSORY to OFF and put the BCM PRGRM fuse back into the instrument panel fuse block. After programming a feature, you can exit the programming mode at anytime. Also, if your vehicle is equipped with the content theft-deterrent system, remember to arm the system before exiting. 2-68