2006 Pontiac Grand Prix Owner's Manual - Page 127

Flash-to-Pass This feature allows the use of the high-beam headlamps to signal the driver in front of you that you want to pass. Pull and hold the exterior lamps control lever to use this feature. When this is done, the following will occur: Heavy snow or ice can overload the wiper motor. A circuit breaker will stop the motor until it cools down. Clear away snow or ice to prevent an overload. • The high-beam headlamps will turn on, while the headlamps are off, in low-beam, or in Daytime Running Lamps (DRL) mode. They will stay on as long as the lever is held in this position. Release the lever to turn them off. • The headlamps will switch to low beam if the headlamps had been in the high-beam mode. To return to high-beam, push the lever. If the vehicle is equipped with the Head-Up Display (HUD), an arrow will appear on the display to indicate that the high beams are on. N(Windshield Wipers): The lever with this symbol, located on the right side of the steering column, operates the windshield wipers. Windshield Wiper Lever Be sure to clear ice and snow from the wiper blades before using them. If they are frozen to the windshield, gently loosen or thaw them. Damaged wiper blades may not clear the windshield well, making it harder to see and drive safely. If the blades do become damaged, install new blades or blade inserts. For more information, see Windshield Wiper Blade Replacement on page 5-60. 9 (Off): Lower the lever to its original position to turn the wipers off. & (Delay): Push the lever up once to this position to set a delay between wiping cycles. Turn the delay adjustment band to set the length of the delay. 3-9